Digital Monitoring Products 1912XR Installationsanleitung PDF herunterladen (Seite 14)

Digital Monitoring Products, Inc. 1912XR Installation Guide

Page 14

1912XR Installation Guide

12 VDC Outputs 3 to 6

14.1 Description

Four 12 VDC, 50mA voltage outputs are provided on the panel's J2 Output Harness to power external relay

coils or other low power indicators. The voltage outputs can be operated by all of the same functions as

Relay Outputs 1 and 2.

When connecting any devices to outputs 3 to 6, subtract the current draw of the device from the panel's

available auxiliary power.

14.2 Harness wiring

To use the voltage outputs on the panel, install a DMP 304 Harness (available separately) onto the 10-pin

header labeled J2. The wire harness descriptions are shown below:

Output Color Harness Wire

3 White/Brown 4

4 White/Red 3

5 White/Orange 2

6 White/Yellow 1

Devices connected to the outputs must be located within the same room as the 1912XR panel.

Telephone RJ Connector

15.1 Description

Connect the panel to the public telephone network by installing a DMP 356 RJ Cable between the panel's

J3 connector and the RJ31X or RJ38X phone jack. Set the 3-pin headers labeled J11 and J12 on the

1912XR to DD for dialer or DDMX operation or MPX for multiplex operation.

15.2 FCC registration

The Model 1912XR complies with FCC part 68 and is registered with the FCC. Registration number:

CCKUSA-18660-AL-R Ringer Equivalence: 1.3B

15.3 Notification

Registered terminal equipment must not be repaired by the user. In case of trouble, the device must be

immediately unplugged from the telephone jack. The factory warranty provides for repairs. Registered

terminal equipment may not be used on party lines or in connection with coin telephones. Notification must

be given to the telephone company of:

a. The particular line(s) the service is connected to

b. The FCC registration number

c. The ringer equivalence

d. The make, model, and serial number of the device

15.4 Ground start

For ground start operation, install the DMP 305 Relay into socket K2.

Tip 1

Tip

Ring

Ring 1

To TELCO Line

To Premises Phone

Place a jumper across

terminals 2 and 7 to provide

phone jack supervision. Loss

of the jumper shows as a

phone trouble on the

Security Command keypad

display.

RJ31X or RJ38X

phone jack

Figure 8: Phone jack wiring

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Digital Monitoring Products 1912XR Installationsanleitung Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Digital Monitoring Products 1912XR