Digital Monitoring Products Canadain XR500 Betriebsanweisung PDF herunterladen (Seite 70)

System Link User’s Guide

Door Control

The Output Status window also allows you to lock and unlock doors and grant door access

events by clicking on the Door tab. Door outputs are at the bottom of the output status

list.

The Door feature allows you to remotely activate the door access relay on Security

Command keypads, Easy Entry keypads, or 733 or 734 Wiegand Interface Modules. You

must know the address number of the keypad or 733 or 734 module to which the door strike

is connected.

You have three commands available under the Door tab: Lock, Unlock, and Access

Status Messages

Door

access successfully sent

: The door access relay on the specified keypad address

has been activated for five seconds.

Unable to send door access

: The System Link program cannot send the door access

information for reasons such as the operator is not authorized for door access or a

communication failure.

Lockdown

Click the Lockdown button to remotely lock all doors programmed as Public Doors in

Device Setup. This feature can be used in emergency situations where it is necessary ton

restrict the site's access to authorized users only.

When the Lockdown button is pushed, System Link sends a message to the panel to turn

off the output door relays for the Public Doors programmed in Device Setup. The relays

then stay off until the next scheduled on time.

During a Lockdown, access cards can still be used to access or egress the area.

Note: The Lockdown feature is available for XR500 Series, XR100 Series, or XR200-485(B)

Panels only.

Contact your representative if you wish to have this feature programmed.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 103 104

Keine Kommentare

Digital Monitoring Products Canadain XR500 Betriebsanweisung Seite 70